This professional style parking system comprises of 4 sensors which are designed to be integrally mounted to the vehicle bumper. The parking system is primarilly designed for installation to the rear of the vehicle and powered via the vehicles reversing lights wiring so that operation is automatic when the vehicle is placed in reverse gear.
This system features a specially designed electronic control unit which has an internal radio transmitter. The audible response from the sensors is generated from a cigarette lighter style plug-in receiver, incorporating a speaker with volume control. These features make this kit ideal for installation to Motorhomes, Caravans & Trailers.
The sensors supplied with this kit are pre-coloured white.
Alternative products
- This Radio Linked kit is also available with White Sensors, ideal for integral installation to Motorhomes and Caravans.
- A Pre-Installed Low Profile Panel version of this system is also available, which simply surface mounts to the rear of the vehicle, providing an even easier installation solution for long vehicles and Caravans.
Operation
The system switches on automatically when reverse gear is selected. An audible tone sounds to confirm operation. Obstructions at the rear of the vehicle are detected approximately 1.5 meters away and indicated by a pulsing audible tone. As proximity to the obstruction is increased, the tone pulses at a faster rate. A continuous tone is produced when the obstruction is approximately 30cm from the vehicle.
Please note: The above stated distances are an approximation of performance only. Actual performance may vary slightly depending upon the quality and style of installation.
This item comprises of
- 4 x 18mm flush mount sensors.
- 3 different sets of sensor mounting frames.
- Miniature RF electronic control unit.
- Remote audible warning unit.
- Installation & Operation Guide
Mounting Options
This kit is supplied with 3 different sensor mounts for varying installation requirements:
- 4 x Level external surface sensor retaining mounts. For installation in to bumpers which have a verticle surface.
- 4 x Angled external surface sensor retaining mounts. For installation in to bumpers which have an angled surface.
- 4 x Internal surface mounts. For a "Factory Fit" style appearance. These adhere to the inner bumper surface and hold the sensor face in position with out the need for outer surface retainers.
Installation options
The parking system features 3 adjustable settings which are selcted using the 3 Dip Switches, located at the electronic control unit:
- High or Low sensitivity
- Narrow or Wide Sensor Detection
- High or Low Audible Warning Volume
Installation service
Please click here for details of our installation service.
Please note: Parking systems are designed only as a driving aid. They should not be considered to replace care and attentiveness while driving!
|
